![]() ![]() Remove the six screws at the bottom of the case to be able to lift up the top, and the motherboard of the unit is revealed (extra cables from my mod in the image below). ![]() ![]() Basically, you need a special “Gamebit” screwdriver, and a regular Philips screwdriver. Here is a good guide to the procedure if you need it. A blue LED mod that goes well with the white paint.ĭisassembling the Super Nintendo (PAL) is rather straight forward.A composite mod on a 3D-printed bracket to replace the missing piece in the case.I performed three modifications to this console: As seen below, the console was in quite terrible condition, with large cracks in the case. In this post, I will to some modifications to a Super Nintendo (SNES), which I bought from a local seller. A couple of such exceptions were a paint job of a Game & Watch Donkey Kong in horrible condition, and a VGA-mod of an original Gameboy. I rarely like to to major modifications to original old hardware, with a few exceptions. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |